|
|
 |
|
|
|
|
SLC DIY: Sigma Lambda Controller Do It Yourself
|
|
SLC DIY is a high performance fully featured Lambda Controller at an affordable price. SLC DIY is recommended only for those with experience putting together DIY electronic kits.
The SLC series Lambda Controllers are the only Lambda Controllers on the
market utilizing programmable switch capacitor and programmable logic
technology. Such advanced technologies allow for high accuracy and fast
response times in an efficient integrated design. |
- 0.01 Lambda accuracy
- 4 digit display
- Pressing the face plate button cycles between; AFR, EGT, Boost, display
- Boost reader with optional onboard boost sensor
- EGT reader with optional EGT probe
- 0-5v EGT linear output
- USB connectivity
- RPM Pickup
- Seven 0-5v analog inputs
- Real-time datalogging
- Programmable Linear Output
- Programmable Narrowband Output
- Over voltage protected
- Reverse voltage protected
- Fused design
|
|
Software and Documentation
Download documentation and software hereWinlog is now supported!!!
Shipping
Shipping and handling is $15
Shipping is via the postal service there is no tracking #
Purchase
|
SLC DIY @ $99
Sept 5 2010: Sorry Out of stock, any new orders will ship the last week of September.
- PCB with soldered programmed microcontroller
- All electronic components
- Case
- Infrared panel
- Sensor plug, contacts, grommets
|
|
Bosch 17014 Wideband Sensor @ $50
- Normally priced @ $70, $50 price with SLC DIY purchase
- Max 1 sensor per SLC DIY order
|
|
|
DIY Cable @ $10
- 18 AWG multistranded
- 6 conductor
- 10ft total length. Typically 6 ft is used for sensor cable and 4ft for Power, Ground, Inputs, and Outputs
|
|
- Normally priced @ $50, $40 price with SLC DIY Purchase
- Use the SLC DIY Display for Boost and EGT, use the gauge for AFR display!!!
|
|
|
EGT Probe @ $40
- K type thermocouple
- 1/8" NPT fitting
- 6.5ft cable length
|
|
|
Boost Sensor @ $35
|
|
|
|
|
|
|
|
